What Tension Should A Chainsaw Chain Be

The Chainsaw Chain Should Be Tight Enough That It Doesn’t Sag Or Come Loose, But Not So Tight That It Puts Undue Strain On The Engine.

It should give about a 1/4 inch from the bar without much effort. Loosen the bar nuts on the side of the chainsaw guide bar. How should you tighten a chainsaw chain:

Trying To Push The Chainsaw Chain With.

Proper chainsaw chain tension is safer, it cuts better and. Clamp the nose of the bar rails with your hand, and use the scrench to move the tensioning screw. Lastly, a tight chainsaw chain could damage the bearings and clutch of the chainsaw as you turn on the tool.

You Can Keep Checking The Tension While Tightening A Chain.

Most chainsaws will come with a tensioning tool you’ll use to adjust your chain. When you pull the chain, three/ fourth of the drive links will. You can check the tension of your chain by lightly pressing down on the middle of the bar with your thumb.

Sticking Out Of The Handle, In.

Lift the nose or turn the tension handle when to tighten the chain:. If a chainsaw’s chain is optimally tight and providing the right amount of tension, then the chain should be a little bit loose across the chainsaw’s guide. These screws are situated to the side of your chainsaw guide bar.

How Do You Know If.

Good tension on your chainsaw blade should allow you to pull the chain just off the guide bar and still have the drive links connected to the grooves of your guide bar [2]. How to tighten a chainsaw chain share watch on let's get started, step 01: Step 3 turn the screwdriver or scrench.